| FAQ | Last Updated |
|---|
|
|
| Are Mopar Performance Magnum V6 valve covers available?
|
Sep 23, 2001
|
| Are pre-magnum (A engine) head bolts the same as magnum head bolts?
|
May 17, 2003
|
| Are underdrive pullies OK to use? Will I have charging problems?
|
Jul 22, 2001
|
| Can I use LA valve covers on a Magnum engine?
|
Jul 22, 2001
|
| Can I use the Nitrous Express Dodge V6/4cly. 50-75HP kit on my Dak?
|
Oct 2, 2001
|
| Cap & rotor part numbers for a Magnum 318
|
Nov 19, 2001
|
| Engine gasket part numbers
|
Jul 22, 2001
|
| How can I clean my engine?
|
Oct 16, 2001
|
| How can I prevent the oil fill tube emulsion?
|
Mar 26, 2002
|
| How do I change my thermostat?
|
Mar 28, 2002
|
| How long should spark plug wires really last?
|
Jul 22, 2001
|
| How much longer is the 5.9L V8 than the 3.9L V6?
|
Oct 7, 2001
|
| How should I install new roller rockers?
|
Oct 16, 2001
|
| How should I install the gaskets for my spark plugs?
|
Mar 9, 2002
|
| I seem to have lost a lot of oil, but can't find it. Where to start?
|
Oct 13, 2002
|
| I'm a little stumped as to a good location for my Blaster SS coil.
|
Oct 16, 2001
|
| Idle Trick (Works better than blocking/disconnecting IAC Solenoid)
|
Oct 15, 2003
|
| My engine seems to spark knock all the time, regardless of what kind of gas I use.
|
Jul 22, 2001
|
| Shift Light (Idiot Light on dash) - Manual Trans ONLY
|
Oct 15, 2003
|
| What are good upgrade/replacement fuel injectors?
|
Oct 15, 2001
|
| What are the advantages to changing my roller rockers?
|
Jul 22, 2001
|
| What are the stock intake/exhaust valve sizes on the Magnum 318?
|
Mar 28, 2002
|
| What brand throttle body should I run?
|
Jul 22, 2001
|
| What diameter hoses do I need for my radiator?
|
Jul 22, 2001
|
| What do intercoolers do?
|
Jul 22, 2001
|
| What is a "ram-air" intake system?
|
Oct 16, 2001
|
| What is ping/spark knock?
|
Oct 25, 2001
|
| What is the head bolt torquing sequence for Magnum V8 engines?
|
May 17, 2003
|
| What is the priming procedure for the oiling system in my Magnum 5.2L?
|
Oct 16, 2001
|
| What is the stock fuel pressure for a Magnum V6 or V8?
|
Jul 24, 2001
|
| What mods work well for the 4.7L V8?
|
Mar 28, 2002
|
| What needs to be changed when I swap a 360 in place of a 318?
|
Jul 22, 2001
|
| What plug wires should I use?
|
Jul 22, 2001
|
| What resistors can I use in place of the IAT sensor?
|
Oct 16, 2001
|
| What spark plugs should I use, and at what gap?
|
Jul 22, 2001
|
| What thermostat do I need?
|
Jul 22, 2001
|
| What type of plastic should I use on my air intake tube?
|
Oct 15, 2001
|
| What would you recommend for an air cleaner setup on a GenII?
|
Mar 28, 2002
|
| What's the compressed thickness of the head gasket on the Magnum engines?
|
Jul 22, 2001
|
| When I use my block heater, my engine stumbles for a few seconds after startup
|
Oct 15, 2003
|
| Where and how should I relocate the IAT sensor?
|
Dec 16, 2001
|
| Where can I find a bore & stroke displacement chart?
|
Nov 19, 2001
|
| Where can I find generic information on spark plugs?
|
Jul 22, 2001
|
| Where is the front Oxygen sensor on the 3.9L/5.2L/5.9L engines?
|
Jul 22, 2001
|
| Which Fumoto oil drain valve is the correct one for my truck?
|
Jul 22, 2001
|
| Which engines were available in which model years?
|
Jun 29, 2003
|
| Who makes a good set of wire looms that fit the MSD 8.5mm wires?
|
Jul 22, 2001
|
| Why do I get a 300 RPM surge while using cruise control?
|
Nov 20, 2001
|
| Will a Ram 360 oil pan work in my Dakota?
|
Jul 22, 2001
|
| Will a TBI 3.9L intake manifold fit my Magnum 3.9L?
|
Oct 17, 2001
|
| Will using a colder thermostat cause problems with my computer?
|
Jul 22, 2001
|
